From f5d41c48b327efbae992316e7c1c6b5afda8a78b Mon Sep 17 00:00:00 2001 From: Attila Lendvai Date: Sat, 13 May 2017 17:49:06 +0200 Subject: X200 install: one more step for the cable of the fingerprint reader --- docs/install/images/x200/disassembly/0006.1.jpg | Bin 0 -> 32364 bytes docs/install/x200_external.md | 11 ++++++----- 2 files changed, 6 insertions(+), 5 deletions(-) create mode 100644 docs/install/images/x200/disassembly/0006.1.jpg (limited to 'docs') diff --git a/docs/install/images/x200/disassembly/0006.1.jpg b/docs/install/images/x200/disassembly/0006.1.jpg new file mode 100644 index 00000000..1888012b Binary files /dev/null and b/docs/install/images/x200/disassembly/0006.1.jpg differ diff --git a/docs/install/x200_external.md b/docs/install/x200_external.md index 79ca3c96..5f74901b 100644 --- a/docs/install/x200_external.md +++ b/docs/install/x200_external.md @@ -108,13 +108,14 @@ completely, since the flash chip is on the other side of the board). Remove these screws:\ ![](images/x200/disassembly/0003.jpg) -Push the keyboard forward, gently, then lift it off and disconnect it -from the board:\ +Gently push the keyboard towards the screen, then lift it off, and optionally +disconnect it from the board:\ ![](images/x200/disassembly/0004.jpg) ![](images/x200/disassembly/0005.jpg) -Pull the palm rest off, lifting from the left and right side at the back -of the palm rest:\ +Disconnect the cable of the fingerpring reader, and then pull up the palm rest, +lifting up the left and right side of it:\ +![](images/x200/disassembly/0006.1.jpg) ![](images/x200/disassembly/0006.jpg) Lift back the tape that covers a part of the flash chip, and then @@ -131,7 +132,7 @@ Connect the 3.3V supply from your PSU to the flash chip (via the clip):\ ![](images/x200/disassembly/0011.jpg) ![](images/x200/disassembly/0012.jpg) -Of course, make sure that your PSU is also plugged in and turn on:\ +Of course, make sure that your PSU is also plugged in and turned on:\ ![](images/x200/disassembly/0013.jpg) This tutorial tells you to use an ATX PSU, for the 3.3V DC supply. The -- cgit v1.2.3-70-g09d2