diff options
| -rw-r--r-- | docs/gnulinux/encrypted_parabola.md | 2 | ||||
| -rw-r--r-- | docs/install/bbb_setup.md | 2 | ||||
| -rw-r--r-- | docs/install/c201.md | 8 |
3 files changed, 6 insertions, 6 deletions
diff --git a/docs/gnulinux/encrypted_parabola.md b/docs/gnulinux/encrypted_parabola.md index b2e40a01..74c74fce 100644 --- a/docs/gnulinux/encrypted_parabola.md +++ b/docs/gnulinux/encrypted_parabola.md @@ -284,7 +284,7 @@ directory to the one you created in the previous steps, so that you can modify f and install software onto it, as if it were the host operating system. To `chroot` into your installation, follow the instructions [on the -Prabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system). +Parabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system). ### Setting up the Locale Locale refers to the language that your operating system will use, as well as some diff --git a/docs/install/bbb_setup.md b/docs/install/bbb_setup.md index f2bb840b..5d684a7f 100644 --- a/docs/install/bbb_setup.md +++ b/docs/install/bbb_setup.md @@ -236,7 +236,7 @@ Output: Verify that the spidev device now exists: - # ls -al /dev/spid + # ls -al /dev/spid* Output: diff --git a/docs/install/c201.md b/docs/install/c201.md index 238c0734..fb39196a 100644 --- a/docs/install/c201.md +++ b/docs/install/c201.md @@ -155,10 +155,10 @@ to be opened. The SPI flash is located next to the write protect screw. Its layout is indicated in the picture below. Note that it is not necessary to connect -`WP#` since removing the screw already connects it to ground. Before -writing to the chip externally, the battery connector has to be -detached. It is located under the heat spreader, that has to be -unscrewed from the rest of the case. The battery connector is located on +`WP#` since after removing the screw it is pulled up weakly to 3v3. Before +writing to the chip externally, the battery has to be unplugged. +Battery connector is located under the heat spreader, that has to be +unscrewed from the rest of the case. It is located on the right and has colorful cables, as shown on the picture below. [![SPI flash |