diff options
Diffstat (limited to 'docs/gnulinux')
| -rw-r--r-- | docs/gnulinux/configuring_parabola.md | 2 | ||||
| -rw-r--r-- | docs/gnulinux/encrypted_parabola.md | 2 | ||||
| -rw-r--r-- | docs/gnulinux/grub_cbfs.md | 2 |
3 files changed, 6 insertions, 0 deletions
diff --git a/docs/gnulinux/configuring_parabola.md b/docs/gnulinux/configuring_parabola.md index 7fc9d688..2aef3624 100644 --- a/docs/gnulinux/configuring_parabola.md +++ b/docs/gnulinux/configuring_parabola.md @@ -55,9 +55,11 @@ careful about this when reading anything on the Arch wiki. Some of these steps require internet access. I'll go into networking later but for now, I just connected my system to a switch and did: + # systemctl start dhcpcd.service You can stop it later by running: + # systemctl stop dhcpcd.service\ For most people this should be enough, but if you don't have DHCP on diff --git a/docs/gnulinux/encrypted_parabola.md b/docs/gnulinux/encrypted_parabola.md index 63c15c0f..62884ecd 100644 --- a/docs/gnulinux/encrypted_parabola.md +++ b/docs/gnulinux/encrypted_parabola.md @@ -65,12 +65,14 @@ article](https://wiki.archlinux.org/index.php/Solid_State_Drives). Edit whole article and keep all points in mind, adapting them for this guide. Securely wipe the drive: + # dd if=/dev/urandom of=/dev/sda; sync NOTE: If you have an SSD, only do this the first time. If it was already LUKS-encrypted before, use the info below to wipe the LUKS header. Also, check online for your SSD what the recommended erase block size is. For example if it was 2MiB: + # dd if=/dev/urandom of=/dev/sda bs=2M; sync If your drive was already LUKS encrypted (maybe you are re-installing diff --git a/docs/gnulinux/grub_cbfs.md b/docs/gnulinux/grub_cbfs.md index d4038bfc..30089f9f 100644 --- a/docs/gnulinux/grub_cbfs.md +++ b/docs/gnulinux/grub_cbfs.md @@ -94,6 +94,7 @@ Use ***cbfstool*** and ***flashrom***. There are available in the *libreboot\_util* release archive, or they can be compiled (see [../git/\#build\_flashrom](../git/#build_flashrom)). Flashrom is also available from the repositories: + # pacman -S flashrom Acquiring the correct ROM image {#rom} @@ -158,6 +159,7 @@ flash it. Ocassionally, coreboot changes the name of a given board. If flashrom complains about a board mismatch, but you are sure that you chose the correct ROM image, then run this alternative command: + # ./flash forceupdate libreboot.rom You should see **"Verifying flash... VERIFIED."** written at the end |