diff options
Diffstat (limited to 'docs/hcl/d945gclf.md')
| -rw-r--r-- | docs/hcl/d945gclf.md | 63 |
1 files changed, 42 insertions, 21 deletions
diff --git a/docs/hcl/d945gclf.md b/docs/hcl/d945gclf.md index a537996c..3f538722 100644 --- a/docs/hcl/d945gclf.md +++ b/docs/hcl/d945gclf.md @@ -39,11 +39,16 @@ Remarks about vendor bios: flashing to install libreboot on this device. Once libreboot is flashed there is no problem to update the firmware internally -Here is an image of the board:\ -\ -Here is an image of the D945GCLF2 board:\ -{width="80%" height="80%"}\ -And SPI SOIC8 flash chip\ +Here is an image of the board: + + + +Here is an image of the D945GCLF2 board: + +{width="80%" height="80%"} + +And SPI SOIC8 flash chip + {width="50%" height="50%"} @@ -53,33 +58,49 @@ How to replace thermal paste and fan This board comes with very crappy disposable loud fan, that one has no bearings, which can not be repaired or oiled properly, do not waste your -time trying to fix it, just buy one chinese same size fan\ +time trying to fix it, just buy one chinese same size fan + {width="50%" height="50%"} -{width="50%" height="50%"}\ -Make sure that new one has same wiring\ -{width="50%" height="50%"}\ -This is a new one, with bearing and maintenable\ +{width="50%" height="50%"} + +Make sure that new one has same wiring + +{width="50%" height="50%"} + +This is a new one, with bearing and maintenable + {width="50%" height="50%"} -{width="50%" height="50%"}\ +{width="50%" height="50%"} + Now remove the both coolers rotating them a bit, slowly, then clean both -silicons and both coolers (removing cmos battery first is recommended)\ -{width="50%" height="50%"}\ +silicons and both coolers (removing cmos battery first is recommended) + +{width="50%" height="50%"} + Put a little bit of non conductive thermal paste on both silicons (only -cpu silicon iis shown on that image)\ -{width="50%" height="50%"}\ +cpu silicon iis shown on that image) + +{width="50%" height="50%"} + Before assembling new fan, some need new longer screws, make sure having -these (on the left is original one, too short for new fan)\ -{width="50%" height="50%"}\ -After that, assemble your new fan into CPU cooler\ -{width="50%" height="50%"}\ +these (on the left is original one, too short for new fan) + +{width="50%" height="50%"} + +After that, assemble your new fan into CPU cooler + +{width="50%" height="50%"} + Finally assemle both coolers on both chips, do not forget put in the CPU fan connector back, and you are done. -Copyright © 2016 Arthur Heymans <arthur@aheymans.xyz>\ -Copyright © 2016 Vitaly Castaño Solana <vita\_cell@hotmail.com>\ +Copyright © 2016 Arthur Heymans <arthur@aheymans.xyz> + +Copyright © 2016 Vitaly Castaño Solana <vita\_cell@hotmail.com> + Permission is granted to copy, distribute and/or modify this document under the terms of the Creative Commons Attribution-ShareAlike 4.0 International license or any later version published by Creative |