aboutsummaryrefslogtreecommitdiff
path: root/docs
diff options
context:
space:
mode:
Diffstat (limited to 'docs')
-rw-r--r--docs/gnulinux/encrypted_parabola.md2
-rw-r--r--docs/install/bbb_setup.md2
-rw-r--r--docs/install/c201.md8
3 files changed, 6 insertions, 6 deletions
diff --git a/docs/gnulinux/encrypted_parabola.md b/docs/gnulinux/encrypted_parabola.md
index b2e40a01..74c74fce 100644
--- a/docs/gnulinux/encrypted_parabola.md
+++ b/docs/gnulinux/encrypted_parabola.md
@@ -284,7 +284,7 @@ directory to the one you created in the previous steps, so that you can modify f
and install software onto it, as if it were the host operating system.
To `chroot` into your installation, follow the instructions [on the
-Prabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system).
+Parabola beginner's guide](https://wiki.parabola.nu/Beginners%27_guide#Chroot_and_configure_the_base_system).
### Setting up the Locale
Locale refers to the language that your operating system will use, as well as some
diff --git a/docs/install/bbb_setup.md b/docs/install/bbb_setup.md
index f2bb840b..5d684a7f 100644
--- a/docs/install/bbb_setup.md
+++ b/docs/install/bbb_setup.md
@@ -236,7 +236,7 @@ Output:
Verify that the spidev device now exists:
- # ls -al /dev/spid
+ # ls -al /dev/spid*
Output:
diff --git a/docs/install/c201.md b/docs/install/c201.md
index 238c0734..fb39196a 100644
--- a/docs/install/c201.md
+++ b/docs/install/c201.md
@@ -155,10 +155,10 @@ to be opened.
The SPI flash is located next to the write protect screw. Its layout is
indicated in the picture below. Note that it is not necessary to connect
-`WP#` since removing the screw already connects it to ground. Before
-writing to the chip externally, the battery connector has to be
-detached. It is located under the heat spreader, that has to be
-unscrewed from the rest of the case. The battery connector is located on
+`WP#` since after removing the screw it is pulled up weakly to 3v3. Before
+writing to the chip externally, the battery has to be unplugged.
+Battery connector is located under the heat spreader, that has to be
+unscrewed from the rest of the case. It is located on
the right and has colorful cables, as shown on the picture below.
[![SPI flash