aboutsummaryrefslogtreecommitdiff
path: root/resources/libreboot
Commit message (Collapse)AuthorAgeFilesLines
* i945/gm45/x4x: update configsLeah Rowe2016-09-0921-347/+479
|
* typofixLeah Rowe2016-09-091-1/+1
|
* typofixLeah Rowe2016-09-092-6/+6
|
* i945, gm45 and x4x: bump coreboot revisionLeah Rowe2016-09-0964-74/+74
|
* Fix low-res screens on T60 (patch from Arthur Heymans)Leah Rowe2016-09-082-0/+175
|
* all i945 and gm45 boards: bump coreboot revisionLeah Rowe2016-09-0846-267/+27
|
* add hda verb to t60 (fixes mic) (patch from Arthur Heymans)Leah Rowe2016-09-081-0/+53
|
* gm45: fix IOMMU (patch from Damien Zammit)Leah Rowe2016-09-0812-0/+61
|
* Add a new target: intel d945gclfArthur Heymans2016-09-0710-0/+1271
| | | | | | | This patch adds all the required files to build libreboot for the intel d945gclf. Signed-off-by: Arthur Heymans <arthur@aheymans.xyz>
* Disable serial port coreboot log output (not needed in release)Leah Woods2016-08-1820-352/+72
|
* Disable EHCI debug for the release (not needed in the release)Leah Rowe2016-08-1817-154/+44
|
* gm45: cleanup of native graphic initArthur Heymans2016-08-1712-0/+240
| | | | | | cleans up and corrects some registers in gm45 native graphic init. Results is that previously incompatible wxga+ screens now have a strip of working display.
* fix overlapping cmos paramters on t400Arthur Heymans2016-08-091-10/+9
| | | | overlapping cmos parametes were result of uncarefull reverting.
* fix error that was caused by incorrect revert.Arthur Heymans2016-08-091-12/+12
|
* fix libreboot build issue with gm45.Arthur Heymans2016-08-0912-25/+62
|
* gm45,reused.list: fix mistake on using hardcoded intel gpuArthur Heymans2016-08-088-9/+8
|
* hardcode use of integrated graphic device on gm45 laptopsArthur Heymans2016-08-089-0/+35
|
* set gm45 vram default to 256MArthur Heymans2016-08-0812-0/+48
| | | | | | The gm45 integrated gpu scales very well with more vram, both for video decoding and games. Setting it to the highest stable value is a good default for libreboot.
* revert hybrid driver cause it does not work on t400Arthur Heymans2016-08-0811-75/+609
| | | | | | Also removes hardcoded use of igd since code is different. Can be added in later patch but since libreboot always loads cmos defaults this might not be necessary.
* update coreboot revision for ga-g41m-es2l (contains some more raminit fixes)Leah Rowe2016-07-271-1/+1
|
* update to latest coreboot revision for ga-g41m-es2lLeah Rowe2016-07-232-47/+1
|
* Update to latest coreboot revision and patch set for GA-G41M-ES2LLeah Rowe2016-07-189-606/+78
|
* GM45 laptops: Update to the latest coreboot revisionLeah Rowe2016-07-1863-841/+1104
|
* Change Leah's surname back to RoweLeah Rowe2016-06-2813-18/+18
|
* x60,t60: delete manually added c4 stateArthur Heymans2016-06-192-147/+0
| | | | | | | The ich7 datasheet "Intel® I/O Controller Hub 7 (ICH7) Family" has a reg called GEN_PMCON_1 in which c3 can automatically be upgraded to c4. This is already set in coreboot.
* Disable native PS2 keyboard initArthur Heymans2016-06-1919-19/+19
| | | | | | Both grub and seabios can do keyboard init on their own. This option only slows down the boot process. On the x60 it even makes the keyboard unresponsive.
* Add sound card config for x60Arthur Heymans2016-06-191-0/+65
| | | | | | | | | | | | | The sound card on the x60 is not configured in coreboot. This causes the headphones not to be automatically detected/used when inserted which it does on the vendor bios. The internal microphone is also not set as default. I found on the coreboot wiki how to get the config from vendor bios. In GNU/linux run: for x in /sys/class/sound/card0/hw*; do cat "$x/init_pin_configs" > pin_"$(basename "$x")"; done for x in /proc/asound/card0/codec#*; do cat "$x" > "$(basename "$x")"; done which gives the pin config of the vendor bios.
* Enable extended states and dynamic L2 cacheArthur Heymans2016-06-013-0/+52
| | | | | | | | | | | | | This patch sets msr bits to enable dynamic L2 cache which is a requirement for C4E, which is also enabled by this patch. the bit for C2E is also set. Those msr bits are taken from later cpus and seem to work fine. C2 state performs particularly bad. Before this patch it consumed ~17-18W. After this patch it dropped to 14W. Idle power usage (C4) seems to remain very similar.
* GA-G41M-ES2L: Update patches to fix NIC in GNU/Linux (autoconfig works now)Leah Woods2016-05-245-48/+207
|
* gm45: 256M default vramArthur Heymans2016-05-2412-0/+214
| | | | | | 352M vram seems to be quite unstable on targets with 4GB or more. 256M has yet to show issues on different ram configurations. This might be a good default for libreboot.
* Revert GM45 352MiB VRAM patch for now, we'll re-add it later once stableLeah Woods2016-05-2212-212/+0
|
* 352M for gm45 now with failsafe if something goes wrong with cmos.Arthur Heymans2016-05-2212-0/+212
|
* Remove patch for 352MiB VRAM on GM45Leah Woods2016-05-2213-256/+0
|
* All board: payload now named payload.elfLeah Woods2016-05-2125-25/+25
|
* ga-g41m-es2l: disable CONFIG_PCIEXP_COMMON_CLOCK in config (bootfix)Leah Woods2016-05-211-1/+1
|
* use usbdebug on ga-g41m-es2lLeah Woods2016-05-211-1/+11
|
* use seagrub on ga-g41m-es2lLeah Woods2016-05-211-2/+4
|
* Use damo22's config for ga-g41m-es2lLeah Woods2016-05-211-20/+8
|
* Fix broken NIC on GA-G41-ES2L, courtesy of damo22 on IRCLeah Woods2016-05-214-30/+377
|
* GA-G41-ES2L: upgrade to recommended coreboot revisionLeah Woods2016-05-212-1/+1
|
* seabios boards: also hardcode cmos settings, like on grub boardsLeah Woods2016-05-203-3/+3
|
* seabios board configs: update to fix broken automated buildLeah Woods2016-05-202-80/+62
|
* Add boards: use a static CMOS option table, for consistencyLeah Woods2016-05-2018-18/+19
| | | | | | | | | | This also forces GM45 to use 352MiB RAM for the Video RAM, for the Intel GPU. It's implemented in such a way where the user configures it using nvramtool. Hardcode it. This should also force the century byte to be reset on GM45, for those users who were affected by this previous issue.
* forgot some newlines in reused.listArthur Heymans2016-05-195-5/+10
|
* set vram on gm45 to 352MArthur Heymans2016-05-1913-5/+256
| | | | | | | | | | | | | This patch enables all vram sizes and sets the default to 352M for libreboot. Normally users have to clear their vram for this to happen. using "nvram -c random" But there a 2 better option: coreboot provides to always load the defaults in its menuconfig update the flashscript to reset cmos Signed-off-by: Arthur Heymans <arthur@aheymans.xyz>
* Implement SeaGRUB and make it the default payload on all current GRUB boardsLeah Woods2016-05-1821-21/+21
|
* finally the correct patch for i945 vramArthur Heymans2016-05-181-10/+16
|
* update configs (fix build errors)Leah Woods2016-05-169-133/+115
|
* i945: path to enable all VRAM options, libreboot config is set to 64MBArthur Heymans2016-05-156-32/+210
|
* Revert "All GRUB board: add equivalent configs for SeaBIOS too."Leah Woods2016-05-1476-10233/+0
| | | | This reverts commit 83ea3644c7110d3b48ec2d44ec059ec36b000f7f.
generated by cgit v1.2.3-70-g09d2 (git 2.47.0) at 2024-11-05 19:50:29 +0000